![]() Note: This board does not support microPython. Program STM32 Blue Pill (STM32F103C8T6) with Arduino IDE The STM32 Blue Pill can be programmed using either the Type-C USB connector (if bootloader is flashed), the STLink USB dongle, or an external USB to 3.3V TTL adapter.Ī set of 2.5mm pitch male headers is included (soldering is required).Ĭheck out the following tutorial for detailed instructions on how to program the STM32 Blue Pill with Arduino IDE: ![]() This development board is pre-flashed with an Arduino bootloader, so you can download the sketch just like other Arduino board. ![]() Further, it allows you to add additional flash by soldering an SPI Flash to the board. It also has multiple communication interfaces including two I2Cs and SPIs, three UARTs, an USB and a CAN. It has an extensive range of I/O and peripherals, including multi-channel Direct Memory Access, several high resolution ADC, and three general purpose 16-bit timers plus one PWM timer. ![]() ![]() It features a 32-bit ARM Cortex M3 processor running at 72MHz frequency with 64Kbytes of flash memory and 20 Kbytes of SRAM. STM32 Blue Pill is a high-performance, breadboard friendly development board with loads of features in a small form factor. ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. Archives
September 2023
Categories |